Cavaliere AP238-PS13-30 Manual de instalación

Busca en linea o descarga Manual de instalación para Campanas De Cocina Cavaliere AP238-PS13-30. Cavaliere AP238-PS13-30 Installation Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir

Indice de contenidos

Pagina 1 - Installation Manual

500 W Warner, Santa Ana CA 92707Technical Support: 714-622-1550cavalierehoods.comInstallation Manual

Pagina 2

IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualied electrician for 220-Volt 50 Hz voltage)It is the customer’s res

Pagina 3 - Important Safety Notice

Page 9PreparationAdvanced Preparations:Be familiar with the controls of the range hood by reading through • Range Hood Operations, Page 12.Place the

Pagina 4

Installations (refer to Page 4 for parts):Measure the distance between stove top and the bottom of range hood. A distance of 27” to 30” is recommended

Pagina 5 - Tools needed:

Figure 8Page 11Installation (Continued)Connect the range hood to a designated standard outlet (please re-7. fer the product label for the suitable vol

Pagina 6 - Parts supplied:

Page 12Range Hood OperationsControl Panel Layout and Buttons Congurations:This range hood is equipped with remote control and heat sensor that will s

Pagina 7 - Height & Clearance

Page 13Range Hood Operations (Continued)Control Panel Layout and Buttons Congurations:Activating Light Function: • Press Light button once to turn

Pagina 8

TroubleshootingPage 14If the range hood or halogen light does not operate 1. after installation:Check if the range hood has been plugged in, make • su

Pagina 9 - Venting Methods

Use and Care InformationOperations:Read and understand all instructions and warnings in this manual before operating the appliance. Save these • instr

Pagina 10 - Electrical Requirements

Measurements and DiagramsInstallation Overview:CDUpper support frameRange hoodRound duct (exhaust)Chimney-mounting bracketAAir Movement DirectionUpper

Pagina 11 - Preparation

All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measurements are estimated.• Overa

Pagina 13 - Installation (Continued)

Page 18Overall without Chiminey:All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch me

Pagina 14 - Range Hood Operations

Page 19Circuit Diagram:Hood-mounting Bracket:

Pagina 15

Page 20Range Hood Assembly:No. Description No. Description1 Chimney-Mounting Bracket 13 Control Panel Assembly2 Upper Standard Chimney 14 Processor Bo

Pagina 16 - Troubleshooting

Page 21Blower Assembly:No. Description No. Description1 Motor 4 Locknut2 Air Chamber 5 Safety Screen3 Squirrel CageElectrical Assembly:No. Description

Pagina 17 - Specications

Page 22WARNINGHazard of Burns!Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching

Pagina 18 - Measurements and Diagrams

Page 23One Year Parts Warranty:For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replac

Pagina 19 - Overall:

Page 24Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and si

Pagina 21 - Hood-mounting Bracket:

500 W Warner, Santa Ana CA 92707Technical Support: 714-622-1550cavalierehoods.com

Pagina 22

Important Safety NoticeRead all Instructions before Installing and operating this applianceThe installation in this manual is intended for qualied in

Pagina 23

Page 2Important Safety NoticeRead all Instructions before Installing and operating this applianceWARNINGYour safety and the safety of others is very i

Pagina 24 - Maintenance

Table of ContentsINSTALLATIONTools needed...3Parts supplied...

Pagina 25 - Warranty

Page 4Parts supplied:Qty: 4 PCS(For sheet rock only)Qty: 2 PCS (30-in models)Qty: 3 PCS (36-in models)Chimney-mounting BracketQty: 6 PCSQty: 4 PCSQty:

Pagina 26 - Disclaimer

Venting RequirementsPage 5Height & ClearanceVent system must terminate to the outside • (roof or side wall).DO NOT terminate the vent system

Pagina 27 - Your Notes

Page 6IMPORTANT:A minimum of 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate-• ly) must be used to maintai

Pagina 28

Venting MethodsPage 7This range hood is factory set for venting through the roof or wall.• Vent work can terminate either through the roof or wall. To

Comentarios a estos manuales

Sin comentarios